01204 SKU
Добавить в избранное
No reviews
No votes yet
Battery-powered electro-hydraulic crimping tool PEGA-300 is used for crimping CU and AL lugs of 16-300 mm2
Поделиться в социальных сетях
- Сross section, mm2: 16, 25, 35, 50, 70, 95, 120, 150, 185, 240, 300;
- Battery-powered electro-hydraulic crimping tool PEGA-300;
- Dies included in the set, mm2: 16, 25, 35, 50, 70, 95, 120, 150, 185, 240, 300;
- Battery Li-Ion 18V - 2 pieces;
- Charger;
- Repair kit;
- Protective gloves;
- Passport products;
- Carrying and stowage plastic case;
- Crimping takes less than one minute regardless to terminal cross section;
- High productivity makes the tool especially convinient in working with a large amount of work related to cable crimping (especially to crimping of big diameter cables);
- Replaceable battery for providing continuous operations is included in the set;
- Lithium-ion batteries of higher capacity for long-term heavy load operations;
- Automatic pressure release - the piston returns to its original position after achieving maximum output;
- Hand pressure release - the piston return to its original position in manual way if operations are not implemented properly;
- The crimping tool is equipped by a double-stroke plunger: during no-load operation the circuit is open, it provides fast oil pumping into the power cylinder, when no-load operation is selected the second circuit is opened which provides maximum force developing;
- Light and sound error alarm;
- The tool is set into a working position by one trigger;
- Lithium-ion batteries are of no memory effect and are of low self-discharge. Even after a long break the tool is always ready to be used;
- The weight of a lithium-ion battery is lighter, but the capacity (energy density) is twice higher than the capacity of NI-MH batteries;
- Due to the temperature sensor the tool automatically stops working if the temperature reaches its peak level (40-60 degrees, depending on a tool) during long-time working;
- Emition of the failure sound signal means that using of the tool is impossible until the temperature becomes normal;
- Due to using of high pressure hydraulic system, the assembly is the most appropriate tool for industrial use;
